N.W.D. Corporation E-Z Pull Trigger Assist

A rifle is only as good as its trigger, and the "E-Z Pull" can make about any trigger better, without costly gunsmithing. The "E-Z Pull" pull can be installed quickly, and can reduce the pull of a gun’s trigger by as much as 50 percent. One "E-Z Pull" can be used on multiple guns, and works on most popular firearms, including: Winchester, Ruger, Remington, Savage and Browning. MSRP is about $40.

E-Z Pull Installation

The E-Z Pull Trigger Assist is designed to fit on most single trigger rifles and shotguns. To accomodate firearms with a shallow trigger guard, the E-Z Pull can be reverse mounted as shown in the picture at right. This reverse mounting works well on Ruger 10-22s and most shotguns.

• Winchester
• Ruger
• Remington
• Savage
• Browning

And other rifles with a trigger guard width of less than .595" Browning A-Bolt, Weatherby, and rifles with a trigger guard between .595 and .630 available upon request.

E-Z Pull Construction

The E-Z Pull Trigger Assist is constructed of durable, non-corrosive aluminum and is offered in black or clear anodized finishes.

Advantages to Using the E-Z Pull Trigger Assist

* Up to 50% trigger pull reduction
* Improves accuracy
* An affordable alternative to   expensive trigger gunsmithing
* Provides a smooth trigger action
* Easily removed and can be used   on multiple firearms

Click on the banner at the top of the page to go directly to E-Z Pull Trigger Assist website.